Instruction for A31s camera conflicted

Answered

smckenzie

• August 12, 2025 00:45

I am trying to setup 2 A31S cameras. The instructions reference a reset button next to the power jack and a red flashing light. There is no reset button and i only se a flashing green light on my cameras that are labeled A31s. How do I set the cams?

0

• 

  Blurams Support

  • August 12, 2025 03:24

  Hello, according to the information you provided, your A31S camera's reset button and the indicator light is flashing green. Please follow the steps below to set up and troubleshoot:
  
  1. Confirm the camera status:
  Devices of model A31S usually support Wi-Fi connection, and the indicator light flashing green indicates that the device is trying to connect to the network or is working.
  
  2. Connect the camera:
  Open the blurams app and make sure your phone is connected to a stable 2.4G Wi-Fi network.
  Open the app and click the "+" button in the upper right corner to add a device.
  Select the "Wi-Fi Connection" method and follow the prompts to connect the device to Wi-Fi.
  
  3. Obtain the correct operation of the device:
  Please move the lens of A31S upwards, and then you will find the Reset button. Please plug in the device when pairing or connecting it, make sure the red indicator light flashes or beeps, and enter the distribution network state.
  During the connection process, the indicator light should change from blinking to green to indicate a successful connection.
  
  4. Normal working condition of the equipment:
  The flashing green light indicates that the device is working and the network connection is normal.
  - If the green flashes for a long time and the connection fails, please make sure:
  The equipment is relatively close to the router during network distribution.
  Wi-Fi password is correct.
  Your router has enabled the 2.4G frequency band.
  
  5. When you need help:
  - If the device cannot be connected to the network for a long time, it is recommended to cut off the power and wait a few seconds before plugging it back in and trying to pair it again.
  You can also try restarting your phone and app to add the device again.
  
  Please confirm the above steps and provide the specific performance or network environment of the device for my further guidance. If necessary, you can tell me if there are any prompts or sound feedback during the network distribution process of your device, so as to better assist you in troubleshooting problems.

  0

Please sign in to leave a comment.